Control Bars

My kite lines are different lengths. What now?
The front lines of a bar are subjected to higher loads, so they may stretch usually over time. It is possible to stretch the lines unequally by practicing f...
Mon, 27 Sep, 2021 at 10:29 PM
What is the difference between the transparent and the massive yellow Rotor Quickrelease?
The transparent version of the Rotor was our first version of the new design and was sold until summer of 2012. The massive yellow Rotor replaced it.  W...
Wed, 22 Sep, 2021 at 12:48 PM
Why is the new SENSOR depower line longer than the last one?
You replace the Sensor depower line and you find it longer than the older version. This is because the attachment point to the massive yellow Rotor 1.1 (not...
Mon, 27 Sep, 2021 at 4:45 PM
My Pigtails / Connectors are frayed in the middle. Are they finished?
Short answer: No The lines are made of a high strength Dyneema line, which has a breaking load of 780kg (!). We splice a pigtail to each end. See a simp...
Mon, 27 Sep, 2021 at 10:27 PM
How do I attach the stopper ball on the end of the virtual 5th line safety?
Sensor 2 Bar The leash ring should be fed through the safety line first. Then push the stopper on and make a figure eight knot. Pull the stopper ball/cover...
Mon, 27 Sep, 2021 at 4:54 PM
I found a knot in my lines. Is this bad?
Short answer: Yes You should try to fix it immediately, because a front line can lose 30% of its strength with an overhand knot in it. You have to softe...
Mon, 27 Sep, 2021 at 4:50 PM
My arms are too short to reach the trim adjuster/ clam cleat. Can I move it closer to me?
Short answer: Yes The Core Sensor Bar  is delivered in the default setting over the sail cloth covered line. The clam cleat may be moved closer but no m...
Mon, 27 Sep, 2021 at 4:51 PM
Can I fly any kite with my CORE Bar?
Disclaimer: CORE Kiteboarding GmbH assumes no liability for damage or injury caused due to an incorrectly trimmed non CORE kite and not complying with the s...
Wed, 22 Sep, 2021 at 12:33 PM
How do I change the chickenloop on the ESP Bar?
In the following video we show you how to change the loop on a 5th HD or ESP Bar. If the pin is sticky and difficult to remove, apply a few drops ...
Wed, 22 Sep, 2021 at 12:33 PM
How to replace the chickenstick on ROTOR QR 1.0
The rubberline is pulled through the QR like shown on the picture. Pull both ends through the chickenstick (less wider end of the stick to the QR) and hold ...
Wed, 22 Sep, 2021 at 12:49 PM